Chrome - Top
Chrome - Rear
Jazz Bass Blend Wiring Diagram |
Fender Jazz Bass Blend Control Plate Assemblies
Prewired controls includes fasteners and your choice of finish for the control plate and push-on dome (or Jazz) knobs. The assembly uses one mini 250KA master volume audio taper split shaft pot, one 250K volume blend pot with split shaft, one mini 250KA master tone audio taper split shaft pot, one .047µF Mylar capacitor, one Switchcraft 1/4" Mono Output Jack, and the finest wire on the market: WBE PTFE 22awg Teflon High Temp Silver Plated Stranded Copper Wire.
Also included with the screws is shrink tubing and one 8" x 12" sheet of copper foil, which is enough to shield your cavities and the bottom half of the rear of your pickguard.
If you would like to change anything, like different knobs, email me. I can adjust your cart for more expensive knobs or even eliminate the cost of knobs altogether should you already have a set. I'm pretty flexible. . . however, I will not wire this with anything but the hi-temp teflon because nothing else comes close to it in looks, function and longevity.
Chrome Plate: with Chrome Knobs : $84.95 
Chrome Plate: with Black Jazz Knobs : $84.95
Chrome Plate: with Black Knobs : $86.95
Chrome Plate: with Gold Knobs : $89.95
Black Plate: with Chrome Knobs : $89.95
Black Plate: with Black Jazz Knobs : $89.95
Black Plate: with Black Knobs : $94.95
Black Plate: with Gold Knobs : $99.95
Gold Plate: with Chrome Knobs : $99.95
Gold Plate: with Black Jazz Knobs : $99.95
Gold Plate: with Black Knobs : $104.95
Gold Plate: with Gold Knobs : $109.95
|
)
)
